Home
loading content

Studio 5000 Logix Designer Level 4: Kinetix 5700 (CIP) Programming

CCN144-A

COURSE DESCRIPTION:

After completing this course, you should be able to configure, test, tune, and program CIP Motion™ axes using the Studio 5000 Logix Designer® application.

Building upon the skills gained in the Studio 5000 Logix Designer Level 3: Project Development (CCP143) course, you will learn how to apply the Logix5000™ architecture to a multi-axis CIP™ motion control system. You will also practice efficient programming skills necessary for translating a machine specification document into reliable ladder logic code.

Because all Logix5000 products share common features and a common operating system, you will be able to apply the motion control configuring and programming skills you learn in this course to any of the Logix5000 controllers that are capable of motion control.

OBJECTIVES:

Upon completion of this course, you should be able to configure, test, tune, and program CIP Motion axes using the Studio 5000 Logix Designer application:

  • Configuring a Studio 5000 Logix Designer Project for Integrated Motion over an EtherNet/IP Network
  • Adding and Configuring EtherNet/IP Drives and Configuring CIP Servo Axes
  • Testing Hardware for Integrated Motion over an EtherNet/IP Network
  • Tuning Axes over an EtherNet/IP Network
  • Programming Instructions to Turn on and Turn off Servo Control
  • Programming Instructions to Home and Stop Axes
  • Programming Shutdown and Recovery Instructions
  • Programming Group Motion Instructions
  • Dynamically Altering Move Parameters and Adding a Virtual Axis
  • Programming Gearing Instructions
  • Programming Position Camming and Time Camming Instructions

COURSE AGENDA:

DAY ONE:

  • Starting a Ladder Diagram for a Studio 5000 Logix Designer Project
  • Testing a Ladder Diagram in a Studio 5000 Logix Designer Project
  • Programming Timer Instructions in a Studio 5000 Logix Designer Project
  • Programming Compare Instructions in a Studio 5000 Logix Designer Project
  • Programming Move Instructions in a Studio 5000 Logix Designer Project
  • Programming Math Instructions in a Studio 5000 Logix Designer Project

DAY TWO:

  • Programming Instructions to Turn on and Turn off Servo Control
  • Programming Instructions to Home and Stop Axes
  • Programming Instructions to Move and Jog Axes
  • Programming Shutdown and Recovery Instructions

DAY THREE:

  • Integrated Practice: Creating a Basic Integrated Motion Application Controlled over an EtherNet/IP Network
  • Programming Group Motion Instructions
  • Dynamically Altering Move Parameters
  • Adding a Virtual Axis

DAY FOUR:

  • Programming Gearing Instructions
  • Programming Position Camming Instructions
  • Programming Time Camming Instructions
  • Integrated Practice: Programming Dependent Motion Instructions for an Integrated Motion Application Controlled over an EtherNet/IP Network
Course Length:

Four days

Course Code:

CCN144-A

Time:

8:00am - 4:30pm

Who should attend?

Individuals who need to configure and program Logix5000 motion control systems should attend this course. In addition, only students who are already familiar with Logix5000 systems and general motion control should attend this course.

Prerequisites

To successfully complete this course, the following prerequisites are required:

  • Completion of the Motion Control Fundamentals course (CCN130) or equivalent knowledge of or experience with motion drives, feedback devices, and velocity and position loop systems
  • Completion of the Studio 5000 Logix Designer Level 3: Project Development course (CCP143) or equivalent experience
Price:

See individual event date for pricing